| NFusion Loader 1.0 First release
nfusion loader 1.0 first release
The do not's first:
Do not "do not interupt the flashing process once you power on the box"
Do not "select boot on the software (use main only)"
1. Have the power turned off on the back of your box .
2. Connect (rs232 null modem) cable between pc & nfusion box.
3. Turn the back power button on.
4. Select your serial port by clicking the com button (com 1 is default). Default baud rate is set at 115200.
5. Click open file and select an nfusion file to be downloaded to your receiver.
6. Click start nfusing and a box will pop up that says "please reboot your stb after clicking ok.
7. Cllick ok then turn on or off by the front power button of your box or use your remote and the software will start loading.
Again "do not interupt the flashing process once you power on the box"
The first file is due to be released within 24 hours if all goes well.
__________________ "It's not enough that we do our best; sometimes we have to do what's required." - Winston Churchill
‘we cannot anticipate today what we shall know only tomorrow’. Karl Popper
Vote for US
  Apply To Be a Moderator Click this Link
Last edited by grynner; December 1st, 2006 at 01:24 PM.
| 
Linear Mode
