Lemon Loader

[grynner]

c&p from another site,thanks goes to Snoops




Lemon Loader



Here is Lemon Loader. Used for fta ird's such as BlueJay, Sat Cruiser, and Techsat

QUICK START
This downloader program has five buttons there are the Open, Com-Baud, Main-Boot, Download and Exit.

Open
- You can select any LSI main s/w file(also key file…) or boot file to download by clicking this button. The name of current file is displayed at the left-top corner.

Com-Baud
- You can select the serial communication setting as Com port and Baud-rate. By clicking this button, the setting is toggled like the following order.
… COM1 : 57600 bps(default)  COM1 : 115200 bps 
COM2 : 57600 bps  COM2 : 115200 bps  …
The current serial-setting information is displayed at the right-top corner.

Main-Boot
- To download the boot file, you must change the download mode by clicking this button once. You can change the download mode with toggling between main file(default) and boot file.

Download
- Click this button to download the target file into your STB. As soon as you click this button, please reboot(turn off and on) your STB… then the download process is activated.

Exit
- Click this button to terminate this download program


i like To use HyperTerm:
Setup:

57600 Bits per Second
8 bits
no Parity
1 Stop Bit
No flow control

you'll need to press the z key on your computer while turning on the power on the BlueJay.
This will allow you to enter the upgrade mode.
press 1 to upgrade the software
press 2 to upgrade the boot sector.
the password is 1234 if asked
enter 11 before sending the file with zmodem.

do NOT rebot the rx after the file has been transfered untill the unit say's good on the screen.

Good luck!!