Enter DN N2 Keys Manually for Pansat/Pansat Clones

[grynner]

c&p from another site,thanks goes to TvDozd




Enter DN N2 Keys Manually for Pansat/Pansat Clones




This process is meant for non-auto-roll bins or those that don't roll the new keys for some reason.

If ur using an auto-roll bin normally the bin rolls the keys and you'll have picture soon.


Please use the KeyRipper to get the new keys.

This instruction was written for Pansat family and all pansat clones. Steps might be a bit different in some stbs.


1. Press Menu.

2. Go to Parental Control.

3. Go to 2nd Pin and enter the pin (Default is 0000).

4. Go down to "Set Default Key" and hit ok.

5. Go up to "Nagravision 2" and hit ok.

6. You should see "Dish Network" in the top right hand corner.

7. First line is "Provider Id", this should be set to "01 01".

8. Next line is the "Key Number", set this to "00".

9. Go to next line that says "Key Data" and enter the first 16 numbers
(8 pairs) here.

10. Go to next line and enter the second 16 numbers here.

11. Hit ok and notice the RED "OK Store" buton flashing in your right buttom corner of the screen.

12. Go back up to "Key Number" and set it to "01".

13. Go down to Key data and enter the first 16 numbers of the second key.

14. Go down to next line and enter the second part of the second key.

15. Hit ok and notice it on the screen flashing.

16. Hit exit a few times and get out of all the menus.

17. Some stbs may show you a black screen for a while, be patient as the bin is rolling the keys, other receivers may show you a "Wait for Picture %" on the screen again be patient the percentage will go above 100% and it's normal just wait and picture will apear.


Only for educational purposes.