Viewsat VS2000 clone shows 100P "----"

[izack]

Foud this site on Google search, Hope I can fix my Clone
Need help for viewsat 2000 Xtreme Clone, by mistake I put Orignal Bin file. Now I am getting Dashes in the STB Screen. Please help me to bring upto life my STB.
I flash the Clone Factory bin then Clone file it is process upto 100 then hang on & display on the screen 100P. After this it is not Rebooting by itself. How I can fix it.
It is written ODS3900FA VO.3 on the Mainboard. Is there any solution to fix MAINBOARD VO.3 any other way.
Any body can have any idea how to fix. There is at J7 9 PINS silver dots are there....
I try to load the clone factory bin, still same....
I try to flash Orignal factory bin & try to clone by another STB still same when turn OFF & ON shows "----"

[goldpan]

With the error your getting i am not finding any fixes for it. Some have had success, but only if getting (0000) and not (----). If you should happen to get it up, you might try this: making viewsat extreme clone into genuine viewsat extreme -------------------------------------------------------------------------------- the main difference between viewsat extreme clone and genuine viewsat extreme is the missing card reader in the clone. The viewsat killer bins use this as a check point to determine whether the receiver is a clone or not. Here is a little modification that was posted on another site that may if applied to your extreme clone enable it to use viewsat bins in your viewsat clone. I have not personally tried this but the original poster of this "rossco" apparently has and it worked for him. Fakeing card reader for viewsat clone repair. You really don't have to install a card reader on a vs extreme clone to make it into a viewsat. Just solder a wire from pin#5 on the card reader plug on the motherboard to ground. It will trick the reciever into believing it has a reader and boot up normally. I tried it and it works.

[izack]

Quote: Originally Posted by goldpan

With the error your getting i am not finding any fixes for it. Some have had success, but only if getting (0000) and not (----). If you should happen to get it up, you might try this: making viewsat extreme clone into genuine viewsat extreme -------------------------------------------------------------------------------- the main difference between viewsat extreme clone and genuine viewsat extreme is the missing card reader in the clone. The viewsat killer bins use this as a check point to determine whether the receiver is a clone or not. Here is a little modification that was posted on another site that may if applied to your extreme clone enable it to use viewsat bins in your viewsat clone. I have not personally tried this but the original poster of this "rossco" apparently has and it worked for him. Fakeing card reader for viewsat clone repair. You really don't have to install a card reader on a vs extreme clone to make it into a viewsat. Just solder a wire from pin#5 on the card reader plug on the motherboard to ground. It will trick the reciever into believing it has a reader and boot up normally. I tried it and it works.

Thanks for your reply
But I have the 5th generation new clone in the market released in Dec/06 after ward, this is the V0.3 mainboard, don't have J3 card connector.
V0.3 board having J7 9 PIn silver holes. This board is diffrent from the old clone fix...If you have any soltion for V.3, please release that info....Thanks