Factory flash helped revive a "dead" box

[grynner]

Factory flash helped revive a "dead" box

Read this carefully this is not a clone revivor in any way and is not inteded to be it is mearly a factory file that seems to repair the problem with OEM receivers ,


this is a factory flash i used to revive a dead veiwsat receiver that apparently had been affected by the clonekill code although (this will not work on clones) this does work on OEM veiwsats that have problems if you get a flash of led then your in luck with this as i have seen so far , i have given this file to probably 15 people that all had sucess with OEM receivers that had problems after the recent clonekills ,

This also works on receivers that only have four dashes also i refer to as veiwsat night rider although it doesnt run back and fourth across the led . and also so far has worked with all 8888 and half leds as this is the common problems seen by most with an original unit my freinds was completely dead just a flicker of led when fliped on after being off for hours, but is now working like a champ.

how toooo.

#1 turn off your unit and leave it off for a while from 5 minute to 4 hours,

#2 open loader 2 or loader one , or hyperterminal my favorite (personally)

#3 connect your veiwsat to the power with switch turned of in the rear,

#4 open up the loader hit transfer or PC-STB ,

#5 flip your back swith on your receiver to power on let it complete ,

#6 load latest PGM and watch (legal FTA)

although this maynot work on all receivers i have found through my test and other aswell it works great with OEM receivers that have been affected by the clonekills of late,

Again this is not for clones and will not help you in any way,…

c&p,thanks goes to email12345

for the attached file,thanks also goes to billybob